Asbestos Handling & Removal Safe Work Method Statement (2026 Standards)
Licensed Class A and Class B non-friable asbestos removal SWMS, decontamination chamber setup, air monitoring, and EPA waste disposal.
Compliance Overview
Overview & Statutory Scope
Asbestos inhalation causes fatal respiratory diseases including mesothelioma, asbestosis, and lung cancer. 2026 regulations strictly enforce licensed removal procedures for friable and non-friable asbestos-containing materials (ACM). A detailed SWMS specifying enclosure containment, negative pressure units (NPU), wet-wiping methods, decontamination procedures, and EPA transport is legally mandatory.
Hierarchy of Hazard Control Measures (2026 Standards)
- Containment: 200um polythene sheeting enclosures with negative air pressure units.
- Dust Suppression: Wet spraying with PVA-solution sealant; no high-speed power tools.
- Decontamination: 3-stage decontamination unit with HEPA vacuum and wastewater filtration.
Risk Assessment Matrix: Primary Hazards & Mandatory Controls
| Identified Hazard | Mandatory Control Measure |
|---|---|
|
Inhalation of microscopic airborne asbestos fibres
|
Erect sealed 200-micron plastic sheeting with airlocks |
|
Enclosure breach / contamination of adjacent areas
|
Continuous independent air monitoring (NATA accredited) |
|
Heat stress inside full disposable coveralls
|
Double bag waste in approved 200-micron labeled asbestos bags |
|
Improper waste bag punctures during transit
|
Full 3-stage wet decontamination prior to leaving enclosure |
Mandatory Personal Protective Equipment (PPE) Register
Legislation, Codes of Practice & Australian / OSHA Standards
- Safe Work Australia Code of Practice: How to Safely Remove Asbestos
- WHS Regulations Chapter 8 (Asbestos)
- EPA Dangerous Goods Transport Act 2024
Asbestos Handling & Class A/B Removal SWMS Template (2026 Standards)
Pre-completed 2026 Word (.docx) document with your trade steps, risk ratings, and rescue procedures. Add your logo and start work immediately.